Installation - Scandomestic WAH 1506 W User Manual

every operation.
Do not climb or sit on the appliance.
INSTALLATION LOCATION AND SURROUNDING
All washing and additional substances are to be kept in a safe place out of the
reach of children.
Do not install the machine on a carpet floor. The obstruction of the openings
by a carpet can damage the machine.
Keep the appliance clear from heating sources and direct sunlight to avoid
plastic and rubber parts to corrode.
Do not use the appliance in humid environments or rooms containing
explosive or caustic gas. In case of water leakage or water splashes let the
appliance dry in the open air.
The appliance must not be installed behind a lockable door, a sliding door or
a door with a hinge on the opposite side to that of the washing machine.
Do not operate the machine in rooms with a temperature of below 5°C. This
can cause damages to parts of it. If it is unavoidable, make sure to drain the
water completely from the appliance after every use (see „Maintenance -
Cleaning of drain pump filter") to avoid damages caused by frost.
Never use flammable sprays or substances in the immediate proximity of the
appliance.

INSTALLATION

Remove all packaging material and transport bolts before using the
appliance. Otherwise, serious damage may result.
This appliance is equipped with a single inlet valve and can be connected to
the cold water supply only.
Mains plug must be accessible after installation.
Before washing clothes for the first time, the product shall be operated once
throughout all the procedures without any clothes inside.
Before using the washing machine, the product shall be calibrated.
Do not put any excessively heavy objects on the appliance, like water
containers or heating devices.
The new hose-sets supplied with the appliance are to be used and that old
hose-sets should not be reused.
Max. Inlet water pressure 1 MPa. Min. inlet water pressure 0.05 MPa.
Make sure the supply cable is not trapped by the machine, it can get