Connections; Dust Cover - Teac TN-175 Owner's Manual

Connect to line input connectors of
amplifier, etc.
Set the PHONO EQ swtich to ON.
Connect to phono input connectors of
amplifier, etc.
Set the PHONO EQ swtich to THRU.
A Analog audio output connectors (L/R)
These output analog audio signals.
The PHONO EQ switch setting changes the type of out-
put signal.
Use the included audio cable (or commercially-available
ones) to connect other equipment to the output connec-
tors of this unit.
White (L) White (L)
Red (R) Red (R)
B
PHONO EQ (audio output setting) switch
ON
Signals that have been amplified by the built-in equal-
izer amp are output from the analog audio output
connectors (L/R).
THRU
The MM cartridge signal is output directly through
the analog audio output connectors (L/R).
Use this when connecting to equipment that has
PHONO inputs.
o When shipped new from the factory, this is set to ON.
4

Connections

D
A B
C
Included AC adapter
R L
Amplifier
ATTENTION
When set to ON, if connected to the PHONO inputs of
an amplifier, for example, the output from speakers and
headphones will be very loud, which could damage
equipment or harm hearing.
C
DC input connector
After completing all other connections, connect the
included AC adapter to this connector.
Confirm that the power plug of the AC adapter is
plugged into a power outlet.
o Do not use any AC adapter other than the one
included.
o The included AC adapter has plugs that can be
changed. Attach the plug that suits the region where
it is being used.
V Be sure to connect the power cord to
an AC outlet that supplies the correct
voltage. Connection to an outlet that
supplies incorrect voltage could cause
fire or electric shock.
V Hold the power plug when plugging it
into an outlet or unplugging it. Never
pull or yank on the power cord.
V Precautions when making connections
o Do not plug the unit in until after making all connections.
o Carefully read the manuals of the devices that you are
connecting and follow their instructions when making
connections.
V Unplug the power cord from the outlet
when you are not planning to use the
unit for an extended period of time.
D
STANDBY/ON button
Press the STANDBY/ON button to turn the unit on or put
it in standby.

Dust cover

Attaching the dust cover
Dust cover
Main unit
Hinge
1
Insert the hinges completely into the
hinge holders at the left and right ends
of the back of the main unit.
2
Align the tops of the hinges with the dust
cover hinge holders and insert them.
o Close the dust cover during playback. Since doing this pre-
vents skipping caused by unintended contact and blocks
external sound pressure, it makes noise less likely to occur.
o Do not open or close it when a record is playing.
Doing so could, for example, cause the stylus to skip.
o Keep it closed whenever possible to keep dust out.
Removing the dust cover
Hold both edges of the dust cover and lift it slowly to remove it
along with the hinges from the unit. Then, remove the hinges
from the dust cover.
Opening and closing the dust cover
Opening
Hold the front edge of the dust cover and gently lift it open
completely until it stops.
The dust cover will stay open in this position.
Closing
Gently lower the dust cover until it is closed.
V Be careful not to pinch your fingers, for
example, when opening and closing the
dust cover.