Table of Contents
Advertisement
Gilson Company, Inc.
1.0 UNCrATING & ASSeMbly INSTrUCTIONS
1. The SS-10 weighs approximately 90lb (40kg). Use
appropriate equipment and manpower to uncrate the
sieve shaker. Wear safety glasses and work gloves.
2. Examine the shipping carton for signs of damage before
opening. Report damage to the shipper immediately.
Leave the carton as intact as possible to facilitate return
shipping, if necessary.
3. Lift the Base Assembly (Item (1). See the Exploded
Diagram on pg. 10) from the carton, and position it on
a solid, level work surface. Examine the unit again for
damage that may have been concealed.
4. The plastic Clearance Spacer (2) is secured for ship-
ping to the top of the SS-10 Base Assembly with three
1/4-20 x 1.75 stainless steel flat-head screws (4). Us-
ing the included Allen key wrench, remove the three
screws and set aside. Leave the spacer on top of the
base assembly.
5. The Sieve Stack Assembly includes the two Clamp Rods
(5), bottom and top Covers (3 and 6), Clamps (9), and
top and base Gaskets (12 and 13), shipped partially
assembled. To complete assembly, rotate the Clamps
so that the tabs are facing outward. Slide the Top Cover
Plate up and secure it to the clamps by installing the
10-32 x 1 Shoulder Bolts (10) through the bottom of
the plate into the threaded holes in the bottom of each
clamp. Tighten Securely.
6. Place the Sieve Stack Assembly on top of the plastic
Clearance Spacer, aligning the three holes in the spacer
and base plate with the threaded holes in the top of the
base assembly. Install the three stainless steel flat-head
screws, and tighten securely.
7. Install the Base Gasket (13) into the recess in the Bot-
tom Cover (3).
8. Move the assembled SS-10 into place on a solid, sub-
stantial, and level work surface capable of supporting
the machine during operation.
9. Insert the female end of the included power cord into
the power connection on the back of the SS-10. Power
ON/OFF is controlled by the rocker switch adjacent to
this connection.
2.0 PreFACe
Gilson's new 1-Touch Vibratory Sieve Shaker for 8in and
200mm sieves combines the latest in electronic control with
proven particle sizing technology for fast, accurate separa-
tions. Three-dimensional sieving action evenly distributes
and continuously reorients particles across the mesh sur-
face to insure optimum sieving performance. The SS-10 is
suitable for a variety of materials with particle sizes from
No.10 (2mm) to No.635 (20µm). Fast-acting sieve clamps
adjust quickly with little effort. Power level, sieving time
and interval pauses are all controlled and programmed on
the touch screen. Up to 99 testing profiles can be stored in
memory to insure exact repeatability.
Page 4
1-Touch Vibratory Sieve Shaker: SS-10
Advertisement
Table of Contents
