Table of Contents
Advertisement
NOTICE
Clip the cylinder side onto the sphere on the lifted cover.
1. Gas shock [P3]
Drill one (1) 10 mm (13/32 in) hole on each side of the rear cargo. It will serve to evacuate the water.
LH SIDE SHOWN
1. Use drill bit 10 mm (13/32 in)[T2]
WARNING
Never place gasoline, flammable or dangerous liquids including container on or in carrier. This can lead to an explosion.
Parts Installation With Accessories
Installation With Cargo Base Kit (860200583)
NOTE: This kit does not come with All-Terrain Trunk Cover Kit.
Install the All-Terrain Trunk Cover Kit normally. It is easier to install this kit before installing the trunk cover on the vehicle.
Drill four (4) 6 mm (15/64 in) holes using marking.
NOTICE
Remain as much on the center of the marking so the cylinder does not get damaged.
9 of 15
about:blank
10/27/2017, 1:15 PM
Advertisement
Table of Contents
