Table of Contents
Advertisement
about:blank
Repeat same operation for RH side.
Tightening Torque
K50 X 20 Torx screws [P15]
2.5 ± 0.5 N•m (22 ± 4 lbf•in)
Lay down trunk cover [P1] onto the top of the rear cargo by aligning the holes of the cargo with the holes of the trunk cover [P1].
NOTICE
Be careful not to take off the seals while installing the trunk cover [P1].Make sure seal is securely glued to the
tonneau cover. If not, press on any part that may be unglued. This is just to keep it in place during the installation, it will be
compressed after installation.
1. Trunk cover [P1]
1. M6 X 45 Hexagonal plastic screw [P4]
2. Flat washer [P5]
Open trunk cover [P1].
Install six (6) M6 X 45 hexagonal plastic screws [P4] and flat washers [P5] on both sides of the trunk cover [P1]. Screw to have a
slight contact between the washer and the trunk cover. Do not tighten screws. Trunk cover should still be able to move forward and
back.
7 of 15
10/27/2017, 1:15 PM
Advertisement
Table of Contents
