Table of Contents
Advertisement
about:blank
1. Machined hook [P2]
2. M5 Square nut [P6]
Install machined hook [P2] inside rear cargo using one (1) M5 X 45 screw [P7] and one (1) washer [P10].
1. M5 X 45 Screw [P7]
2. Washer [P10]
3. Machined hook [P2]
Tightening Torque
M5 X 45 screw [P7]
3.25 ± 0.25 N•m (29 ± 2 lbf•in)
Repeat same operation for RH side.
Drill eight (8) 5.5 mm (7/32 in) holes into rear cargo using markings.
NOTICE
Drill only 4.5 mm (.177 in) deep with drill bit 5.5 mm (7/32 in)[T1].
NOTE: A piece of tape on the drill bit helps to prevent drilling too deep.
1. Use drill bit 5.5 mm (7/32 in)[T1]
NOTE: Near LinQ hole, only the marking furthest from cage must be drilled.
4 of 15
10/27/2017, 1:15 PM
Advertisement
Table of Contents
