Table of Contents
Advertisement
about:blank
1. M6 X 45 Hexagonal plastic screw [P4]
2. Flat washer [P5]
Close trunk cover [P1].
NOTE: Rear seal must be sufficiently compressed.
Push the trunk cover towards the front of the vehicle and tighten screws while pushing.
Inspect the seal contour to make sure there is no gap between the trunk cover and the cargo box. Inspect the seal to make sure it is
compressed enough to prevent water from dripping inside.
1. Trunk cover [P1]
2. Inspect seal contour
NOTICE
Make sure to push in the center and that the cover is not misaligned.
When properly positioned tighten to specification.
Tightening Torque
M6 X 45 hexagonal plastic screws [P4]
8 ± 1 N•m (71 ± 9 lbf•in)
Open trunk cover [P1].
Assemble gas shock [P3] starting with the side on the fixed part.
8 of 15
10/27/2017, 1:15 PM
Advertisement
Table of Contents
