Table of Contents
Advertisement
Output Scaling The analog output level of the Model 5130 is configurable. The
Chassis GND
02/25/00
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
standard output is +10 volts for the entire probe range. Shown is a
table of other common output voltages that are available. (P6 - P10 set
the scale factor while P5 is an offset jumper for configuration of bipolar/
unipolar output.)
Configuration.
+10V (Bipolar) *
+ 5V (Bipolar)
0 to 10V (Unipolar)
*default setting
NOTE:
The voltage on -ANALOG OUT will be the negative of
+ANALOG OUT. If you want a negative unipolar output,
set up the jumpers as in case 3 above and use the
-ANALOG OUT output. This will give you a 0 to -10 V
swing.
A jumper has been provided allowing the chassis of the Model 5130 to
be either grounded or ungrounded. See Appendix A for more
information on grounding.
Configuration
Chassis DC Grounded *
Chassis AC Grounded
*default setting
P6
P7
P8
P9
IN
OUT
IN
OUT
IN
OUT
IN
IN
IN
OUT
IN
IN
P13
IN
OUT
Microsense II Model 5300 Gaging System - 39
P10
P5
IN
IN
IN
IN
IN
OUT
Advertisement
Table of Contents
