WARNING
Improper installation, adjustment, alteration,
service or maintenance can cause property
damage, injury or death, and could cause
exposure to substances which have been
determined by various state agencies to
cause cancer, birth defects, or other
reproductive harm. Read the installation,
operating, and maintenance instructions
thoroughly before installing or servicing this
equipment.
CAUTION
As with all infrared equipment, clearances to
combustible material are critical. Be sure all
units have reflectors installed along the entire
length of the tube, and that they are not
mounted at an angle greater than 45° from the
horizontal plane.
To prevent premature heat exchanger failure do
not locate ANY gas-fired units in areas where
chlorinated, halogenated, or acid vapors are
present in the atmosphere.
PLEASE BE SURE TO LEAVE IT WITH THE OWNER WHEN YOU LEAVE THE JOB.
I I N N S S T T A A L L L L A A T T I I O O N N A A N N D D S S E E R R V V I I C C E E M M A A N N U U A A L L
l l o o w w i i n n t t e e n n s s i i t t y y g g a a s s - - f f i i r r e e d d p p r r e e s s s s u u r r i i z z e e d d i i n n f f r r a a r r e e d d h h e e a a t t e e r r s s
THIS MANUAL IS THE PROPERTY OF THE OWNER.
FOR YOUR SAFETY
IF YOU SMELL GAS:
1. Open windows (indoor installation only).
2. Do not touch electrical switches.
3. Extinguish any open flame.
4. Immediately call your gas supplier.
The use and storage of gasoline or other
flammable vapors and liquids in open
containers in the vicinity of this unit is
hazardous.
IMPORTANT
The use of this manual is specifically intended
for a qualified installation and service agency.
A qualified installation and service agency
must perform all installation and service of
these appliances.
I I n n s s p p e e c c t t i i o o n n o o n n A A r r r r i i v v a a l l
1.
Inspect unit upon arrival. In case of damage, report it
immediately to transportation company and your local
Modine sales representative.
2.
Check rating plate on unit to verify that power supply
meets available electric power at the point of installation.
3.
Inspect unit upon arrival for conformance with description
of product ordered (including specifications where
applicable).
9-503.3
5 5 H H 7 7 5 5 2 2 8 8 9 9 A A R R e e v v . . C C
May, 2001
m m o o d d e e l l L L M M / / H H M M
Need help?
Do you have a question about the LM and is the answer not in the manual?
Questions and answers