Advertisement
7. TROUBLESHOOTING
PROBLEM
Jack will not lift the load
Jack does not lift high enough or feels
spongy
Jack lifts poorly
Jack lifts but will not hold load
Jack will not lower completely
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
POSSIBLE CAUSE
1. Overloaded
2. Oil level low
3. Release valve not correctly closed
4. Air in system
5. Piston rod not functioning
6. Packing worn or defective
1. Oil level too high or too low
2. Worn seals
3. Air in system
4. Release valve not closed
1. Pump packing or valves malfunctioning
2. Oil is dirty
3. Air in the system
1. Release valve partially open
2. Dirt on valve seats
3. Air in the system
4. Faulty seals
5. Packing worn or defective
1. Unit requires lubrication
2. Piston rod bent or damaged
3. Jack frame/link system distorted due to
overloading/poor positioning
4. Air in system
5. Release valve partially closed
6. Jack spring damaged
01284 703534
Original Language Version
REMEDY
1. Use jack with adequate capacity
2. Top up oil
3. Check and close release valve
4. Open release valve and pump the handle a few
times
5. Clean and replace oil
6. Replace packing
1. Fill or remove excess oil
2. Return jack to local service agent
3. Open release valve and pump the handle a few
times. Close valve and retry
4. Check and close release valve
1. Replace packing and/or replace valves
2. Replace oil
3.Open release valve and pump the handle a few
times. Close valve and retry
1. Check and close release valve
2. Lower jack, close release valve. Place foot on front
wheel and pull up lifting arm to full height by hand.
Open the release valve to lower the arm
3. Open the release valve and pump the handle a few
times. Close valve and retry
4. Replace or contact local service agent
5. Replace packing
1. Oil all external moving parts
2. Replace rod or contact local service agent
3. Replace damaged parts or contact local service
agent
4. Open release valve and pump handle a few times.
Close valve and retry
5. Check and fully open release valve
6. Replace spring or contact service agent
sales@sealey.co.uk
www.sealey.co.uk
2200HL.V3 | Issue:1 31/08/17
Advertisement
