Table of Contents
Advertisement
connect the fax/modem to the board Wake On Modem connector
for working this feature.
Suspend Mode
After the selected period of system inactivity (1 minute to 1 hour),
all devices except the CPU shut off. The default value is "Disabled".
System will never enter SUSPEND mode
Disabled
Defines the continuous idle time before the system
entering SUSPEND mode.
1/2/4/6/8/10/2
If any item defined in (J) is enabled & active,
0/30/40
SUSPEND timer will be reloaded
Min/1 Hr
HDD Power Down
If HDD activity is not detected for the length of time specified in this
field, the hard disk drive will be powered down while all other
devices remain active.
Soft-Off by PWR-BTTN
This option only works with systems using an ATX power supply. It
also allows the user to define which type of soft power OFF
sequence the system will follow. The default value is "Instant-Off".
This option follows the conventional manner systems
perform when power is turned OFF. Instant-Off is a soft
Instant-Off
power OFF sequence requiring only the switching of the
power supply button to OFF
Upon turning OFF system from the power switch, this
option will delay the complete system power OFF
sequence by approximately 4 seconds. Within this delay
Delay 4 Sec.
period, system will temporarily enter into Suspend Mode
enabling you to restart the system at once.
Wake-Up by PCI card
If enable this item, the system can automatically resume when the
PCI Modem or PCI LAN card receives an incoming call.
Power On by Ring
This option allows the system to resume or wake up upon detecting
any ring signals coming from an installed modem. The default value
is "Enabled".
Resume by Alarm
If enable this item, the system can automatically resume after a
fixed time in accordance with the system's RTC (real time clock).
Phoenix-Award BIOS Utility
PC 8153 User's Manual
49
Advertisement
Table of Contents
