Table of Contents
Advertisement
Before attempting to install, it is worth checking that the ignition system performs
satisfactorily.
See figure 12.
Set the right hand control knob to the off position marked
Depress the right hand control knob and rotate it anticlockwise through the ignition
position marked
as the integral piezo operates. A spark should be seen between the electrode and pilot
tip
If there is no spark check the following: -
.
Ensure that the electrode lead is connected to the terminal at the base of the
!
electrode.
If the above is correct, check for damage to the electrode lead.
!
7. FITTING THE CERAMIC FUEL EFFECT
AND BURNER COMPARTMENT WALLS
1. The door is secured with a locking screw. Remove the
screw with the allen key supplied (See figure 8). Open the
door.
2. Remove the front grate. To do this, hold firmly and lift.
3. Place the rear ceramic wall against the back of the
firebox.
4. The rear ceramic wall must be located onto the ledges at
the back of the rear base ceramic (See figure 9). To achieve
this, hold the rear ceramic wall against the rear of the
firebox at its uppermost position. Whilst holding the rear
ceramic wall in this position locate the rear ceramic base
coal into position (See figure 9). The rear wall can now be
released. Ensure that the rear ceramic wall sits on the ledge
at the back of the rear base coal.
5. Fit the left hand side wall against the left hand side of the
firebox. Locate the bottom of the side wall into the channel
along the bottom of the firebox (See figure 10). Supplied with the stove are two ceramic
retaining brackets. One for each side of the firebox. Hold the ceramic side wall against
the steel firebox plate and slide the long leg of a retaining bracket behing the steel
INSTALLER GUIDE
6. IGNITION CHECK
to the pilot ignition position marked
Page 12
!
.
. A 'click' will be heard
Figure 8.
Advertisement
Table of Contents
