Cleaning Modes - Shark APEX AZ1000 Series Owner's Manual

WHOLE-HOME CLEANING
POWER SWITCH
Press power button to turn on vacuum.
Please note the brushrolls will not spin
unless the wand is reclined.
BRUSHROLL INDICATOR LIGHT
INDICATOR LIGHT
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushrolls are spinning and working as they should.
Solid Red: There is a jam in the brushroll area. Turn off the vacuum and unplug it, then remove
any blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn off the vacuum, unplug it, and
remove any blockages. Let the vacuum cool down for at least 60 minutes before restarting.
See Troubleshooting section for more information.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please set to Carpet/Low Pile. NOTE: For
particularly stubborn stuck-on dust messes, set to Carpet/Low Pile mode.
s h a r kc l e a n . c o m
SETTINGS
SURFACE SELECTOR
Thick Carpet & Area Rug Cleaning
Set surface selector to Thick Carpet/Area
Rug.
Carpet & Low Pile Cleaning
Set surface selector to Carpet/Low Pile to
increase the speed of the brushrolls and to
help remove stuck-on dust and debris.
Hard Floor Cleaning
Set surface selector to Hard Floor.
NOTE: The brushrolls will spin in all settings.
WHOLE-HOME CLEANING

CLEANING MODES

UPRIGHT
To engage brushrolls, step on floor nozzle
and tilt handle back.
ABOVE-FLOOR—HANDLE
Press the Handle Release latch to detach the
handle from the wand.
LIFT-AWAY®
Press the Lift-Away button to detach the pod
from the floor nozzle.
NOTE: All accessories are compatible with both the wand and the handle.
ABOVE-FLOOR—WAND
Press the Wand Release button to detach the
wand from the pod.
LIFT-AWAY®
With pod removed, press the Wand Release
button to detach the wand from the floor
nozzle.
s h a r kc l e a n . c o m