Table of Contents
Advertisement
SETUP menu
User preference settings.
•
Fahrenheit or Celsius.
Select the temperature display mode.
•
Backlight timeout.
Sets the time from last button press that the backlight will turn off. Range: 10 (default) -30 seconds. Note: long backlight
timeouts will reduce battery life. If the thermostat is powered from 24VAC, the backlight timeout can be set to "0" which will
keep the backlight on continuously.
•
temperature sensor calibration.
Change the temperature calibration by +/- 7 degrees. Use the Up/Down arrow buttons to change to the desired temperature
displayed.
•
Status Line Display.
Select Setpoints or Relative Humidity to be displayed on the upper status line.
SYSTEM menu
•
System type
Select the system type, STANDARD or HEAT PUMP TYPE (Standard systems only).
•
Select fan type: gas (typical default setting) or electric
•
Change over type (Heat Pump systems only).
Select the Changeover type: Changeover WITH COOL (typical default setting) or Changeover WITH HEAT.
Z-WAVE menu
This menu item allows the thermostat to be enrolled to the Z-Wave network. Follow the instructions shown
in the Z-Wave® Operation section (page 18) to enroll the Thermostat onto the network.
INFO menu
The INFO menu displays information about the thermostat. Use the Up/Dn buttons to scroll through the
various items.
Copyright © Ecolink Intelligent Technology
TBZ500_manual_8_5x5_5_inch
Combined_RDN1240221.indd 23
Menu Mode Screen
Setup (user preference settings)
•
System (HVAC system setup)
•
Zwave (Z-Wave network install or
•
remove)
Info (Displays thermostat version
•
and setup info)
Thermostat information displayed:
•
Version: Thermostat firmware
version
•
Zwave: Z-Wave firmware
version
•
Node ID: Z-Wave Node ID
•
Home ID: Z-Wave Home ID
•
System type: displays current
System Type settings (Standard or
Heat Pump)
•
If System Type = Standard
FAN TYPE displays current Fan Type
setting
If System Type = Heat Pump
•
CHANGEOVER TYPE displays current
Change Over valve (reversing valve)
setting
•
AC or Battery Powered: AC POWER
will be displayed if power by 24VAC
23
24-02-2021 18:55
Hide quick links:
Advertisement
Table of Contents
