Table of Contents
Advertisement
THERMOSTAT SETUP: CONFIGURE FOR HVAC SYSTEM
The thermostat must be set up for the correct HVAC system type and configuration for proper operation.
Preset HVAC System settings
The thermostat is preset for the following typical HVAC system configuration:
•
HVAC system type: Standard gas/electric
•
HVAC fan type: Gas heat
•
HVAC heating stages: one
•
HVAC cooling stages: one
If the thermostat is installed on this type HVAC system, the System setup does not need to be changed.
Installation is complete
For thermostats installed on a Heat Pump HVAC system or any HVAC configuration other than the preset settings, the System
settings need to be changed in the SYSTEM setup menu to match the HVAC system.
Changing the HVAC System Setup
To change the thermostats HVAC system settings, first select the Menu Screen and then select the SYSTEM menu. Follow
instructions below to access the SYSTEM menu.
Entering Menu Mode
To change the System setup, go to the thermostats Menu Mode and select SYSTEM. From there select the correct HVAC settings
to match the installation type. Press and hold the FAN button to enter the Menu Mode. SETUP is the first menu item displayed.
Press the down button to advance to the SYSTEM screen.
Copyright © Ecolink Intelligent Technology
TBZ500_manual_8_5x5_5_inch
Combined_RDN1240221.indd 13
Note:
To conserve battery life, the thermostat
backlight turns off after a short time of
no activity.
The first press of any button will turn
on the backlight but will not initiate
any action other than turning on the
backlight. Press the button again to
initiate the action desired. If the backlight
is already on, button presses work with
the first press.
13
24-02-2021 18:55
Hide quick links:
Advertisement
Table of Contents
