Safety Precautions - Sentry Voyager Series Installation & Operation Manual

SAFETY PRECAUTIONS

TO PREVENT ANY RISK
OF ELECTRIC SHOCK OR FIRE,
READ THIS MANUAL CAREFULLY
BEFORE INSTALLING THE EQUIPMENT.
This device is not intended for use by persons (including children) with physical, sensory
or mental disability, or by persons lacking experience or knowledge, unless they have
received from a person in charge of their safety adequate supervision or preliminary
instructions on how to use the device.
Before Installation.
In order to avoid overcharging or irreversible damage to the materials, please follow
closely all recommendations cited below. Do not install this system near inflammable
materials. An owner should seek guidance from an authorized Sentry dealer or the
factory.
•
Do not install this device near a heat source.
•
Do not install in a gasoline engine room or in area near flammable liquids or
gases.
•
It should not be installed in an airtight or poorly ventilated area.
•
All ventilation ducts must be unobstructed.
•
Leave at least 4" (10cm) clearance around the device for proper ventilation.
•
Mount in a vertical position, to create natural ventilation for the charger.
Note that the wiring connections are at the bottom of the charger.
•
All electrical connections to and from the charger must remain
accessible at all times.
Connecting the Device.
In order to avoid all risk of electric shock or irreversible damage to the device, please
follow very carefully the following recommendations
•
This device is set to be connected to a single phase network 230V 50/60Hz or
115V 60Hz (except 10A & 15A)
•
Follow ABYC and all other applicable standards for proper installation of this
device.
•
In order to protect the occupants, the input point must be attached to a
3