1.1 Further information........................... 6 1.2 Symbols and signal words....................... 7 Safety instructions............................. 9 Features............................... 13 Installation..............................14 4.1 Dealing with lithium batteries..................... 16 Connections and controls........................18 Technical specifications........................21 Cleaning............................... 23 Protecting the environment......................24 VP-m20 Video BiLight Panel LED spotlight...
Page 4
VP-m20 Video BiLight Panel LED spotlight...
Our products and user manuals are subject to a process of continuous development. We there‐ fore reserve the right to make changes without notice. Please refer to the latest version of the user manual which is ready for download under www.thomann.de. VP-m20 Video BiLight Panel LED spotlight...
Our online guides provide detailed information on technical basics Online guides and terms. Personal consultation For personal consultation please contact our technical hotline. If you have any problems with the device the customer service will Service gladly assist you. VP-m20 Video BiLight Panel LED spotlight...
NOTICE! This combination of symbol and signal word indicates a pos‐ sible dangerous situation that can result in material and environmental damage if it is not avoided. VP-m20 Video BiLight Panel LED spotlight...
Page 8
General information Warning signs Type of danger Warning – dangerous optical radiation. Warning – suspended load. Warning – danger zone. VP-m20 Video BiLight Panel LED spotlight...
Extend the operating life of the device by regular breaks and by avoiding frequent switching on and off. The device is not suitable for continuous operation. VP-m20 Video BiLight Panel LED spotlight...
Page 10
NOTICE! Risk of fire Do not block areas of ventilation. Do not install the device near any direct heat source. Keep the device away from naked flames. VP-m20 Video BiLight Panel LED spotlight...
Page 11
NOTICE! Risk of overheating The distance between light output and the illuminated surface must be more than 1.5 m (19.7in). Provide sufficient ventilation. The ambient temperature must always be below 40 °C (104 °F). VP-m20 Video BiLight Panel LED spotlight...
Page 12
50 % of their capacity and then switch off the device. Store the device at room temperature or cooler in an envi‐ ronment as dry as possible. If the batteries are stored for a longer period, recharge them to 50 % every three months. Fully charge the batteries only shortly before use at room temperature. VP-m20 Video BiLight Panel LED spotlight...
For technological reasons, the light output of LEDs decreases over their lifetime. This effect increases with higher operating temperature. You can extend the service life of the illuminants by providing adequate ventilation and operating the LEDs with the lowest possible brightness. VP-m20 Video BiLight Panel LED spotlight...
Work from a stable platform whenever you install or move the device or when you perform any kind of maintenance. Block access under the work area. VP-m20 Video BiLight Panel LED spotlight...
Page 15
NOTICE! Risk of overheating The distance between light output and the illuminated surface must be more than 1.5 m (19.7in). Provide sufficient ventilation. The ambient temperature must always be below 40 °C (104 °F). VP-m20 Video BiLight Panel LED spotlight...
In the event of a short circuit, overheating or mechanical damage, lithium bat‐ teries can cause severe injuries. Follow the advice on the correct handling of lithium batteries in the present sec‐ tion. When handled correctly and appropriately lithium batteries pose no risk. VP-m20 Video BiLight Panel LED spotlight...
Page 17
Before disposing of the device remove the lithium batteries. Protect used lithium batteries against potential short circuits, e.g. by covering the poles with adhesive tape. Only use powder extinguishers or other suitable extinguishing agents to extinguish a burning lithium battery. VP-m20 Video BiLight Panel LED spotlight...
Connections and controls Connections and controls VP-m20 Video BiLight Panel LED spotlight...
Page 19
If the charge control LED lights up red, the internal battery is being charged. When the LED lights up green, the bat‐ tery is fully charged. 5 [CW] Brightness control (cool white) 6 [WW] Brightness control (warm white) 7 Bracket for hanging or tripod mounting VP-m20 Video BiLight Panel LED spotlight...
Page 20
Connections and controls 8 Locking screws for the bracket 9 Barn door VP-m20 Video BiLight Panel LED spotlight...
Power consumption 45 W Power supply Power adapter, 100 - 240 V 50/60 Hz Operating voltage 15 V / 5 A , centre positive Battery / rechargeable Battery type Lithium-ion battery Voltage 11 V VP-m20 Video BiLight Panel LED spotlight...
Page 22
Dimensions (W × H × D), 182 mm × 182 mm × 71 mm w/o barn doors Weight 1.5 kg Ambient conditions Temperature range 0 °C…40 °C Relative humidity 20 %…80 % (non-condensing) VP-m20 Video BiLight Panel LED spotlight...
Protect used lithium batteries against potential short circuits, e.g. by covering the poles with adhesive tape. Dispose the built-in lithium batteries together with the device. Please check for an appropriate reception facility. VP-m20 Video BiLight Panel LED spotlight...
Page 25
Dispose of this device through an approved waste disposal firm or through your local waste facility. When discarding the device, comply with the rules and regulations that apply in your country. If in doubt, consult your local waste disposal facility. VP-m20 Video BiLight Panel LED spotlight...
Page 26
Notes VP-m20 Video BiLight Panel LED spotlight...