Advertisement
L39"Albatros" 90mm edf
Place sub leading edge and flap and aileron edges, mark edges through sheet, easier for later
Place servo doublers and scrap fills for hinges and horns, place ribs from scrap for flaps, cut ribs for
taking flap and aileron leading edges,
Place servos ,make openings at bottom and mark hinge lines flap and aileron. Note for the flap servo
they should be orienting the horn to the left or right for both wings both the same, do not forget to
place scrap balsa in the mid trailing edge for the wing fasteners
Place wing assembly on work plate and fasten at the X marked spots with the 3x6 help former under
the wing see the position on the drawing for this.
Pagina 12
Advertisement
