Table of Contents
Advertisement
Quick Links
INSTRUCTIONS FOR INSTALLATION, SAFE OPERATION AND MAINTENANCE
Understand manual before use. Operation of this device without understanding the manual and
WARNING
receiving proper training is a misuse of this equipment. Obtain safety information at tft.com/
serial-number
This instruction manual is intended to familiarize fi refi ghters and maintenance personnel with the operation, servicing and
safety procedures associated with the ER Bubble Cup fi re fi ghting nozzles.
This manual should be kept available to all operating and maintenance personnel.
TASK FORCE TIPS LLC
MADE IN USA • tft.com
©Copyright Task Force Tips LLC 2002 - 2019
MANUAL: ER Bubble Cup
ER BUBBLE CUP
DANGER
PERSONAL RESPONSIBILITY CODE
The member companies of FEMSA that provide emergency response
equipment and services want responders to know and understand the
following:
1. Firefi ghting and Emergency Response are inherently dangerous activities
requiring proper training in their hazards and the use of extreme caution
at all times.
2. It is your responsibility to read and understand any user's instructions,
including purpose and limitations, provided with any piece of equipment
you may be called upon to use.
3. It is your responsibility to know that you have been properly trained in
Firefi ghting and /or Emergency Response and in the use, precautions, and
care of any equipment you may be called upon to use.
4. It is your responsibility to be in proper physical condition and to maintain
the personal skill level required to operate any equipment you may be
called upon to use.
5. It is your responsibility to know that your equipment is in operable
condition and has been maintained in accordance with the manufacturer's
instructions.
6. Failure to follow these guidelines may result in death, burns or other
severe injury.
Fire and Emergency Manufacturers and Service Association
FEMSA
P.O. Box 147, Lynnfi eld, MA 01940 • www.FEMSA.org
3701 Innovation Way, Valparaiso, IN 46383-9327 USA
800-348-2686 • 219-462-6161 • Fax 219-464-7155
Nozzles
®
LKB-200 July 29, 2018 Rev01
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Task Force Tips ER Bubble Cup
Summary of Contents for Task Force Tips ER Bubble Cup
- Page 1 This instruction manual is intended to familiarize fi refi ghters and maintenance personnel with the operation, servicing and safety procedures associated with the ER Bubble Cup fi re fi ghting nozzles. This manual should be kept available to all operating and maintenance personnel.
-
Page 2: Table Of Contents
CAUTION indicates a potentially hazardous situation which, if not avoided, could result in minor CAUTION or moderate injury. NOTICE is used to address practices not related to physical injury. NOTICE ©Copyright Task Force Tips LLC 2002 - 2019 LKB-200 July 29, 2018 Rev01... -
Page 3: Safety
3.0 GENERAL INFORMATION Task Force Tips ER Bubble Cup nozzles have a clean far reaching dual fl ow straight and fog pattern that is designed exclusively for use with the EF1 monitor. The nozzle stream is adjustable from off (closed), to low fl ow straight stream, high fl ow straight stream, and fog. -
Page 4: Specifications
There is a wide variety of foam concentrates. Each user is responsible for verifying that any foam WARNING concentrate chosen to be used with this unit has been tested to assure that the foam obtained is suitable for the purpose intended. ©Copyright Task Force Tips LLC 2002 - 2019 LKB-200 July 29, 2018 Rev01... -
Page 5: Flow Characteristics
fl uid type, fl uid/water ratio, fl uid temperature, pressure, and fl ow at the nozzle. It is the operator’s responsibility to determine that the system provides adequate reach for the intended purpose. Trajectory chart Figure 4.1 ©Copyright Task Force Tips LLC 2002 - 2019 LKB-200 July 29, 2018 Rev01... -
Page 6: Nozzle Controls
Activate the electronic control to the off position for at least 3 seconds to reset. The ER Bubble Cup nozzles have full pattern control from Off through low fl ow patterns and high fl ow patterns. The nozzle can be operated manually by turning the SHAPER clockwise (as seen from the operating position behind the nozzle) to move to the straight stream position. -
Page 7: Aspirating Sleeve
The aspirator may be gripped and pushed back to it’s retracted position if fog patterns are needed. A) Retracted Position - unaspirated ASPIRATING SLEEVE SHAPER EXTENDED TO WHITE LINE B) Extended Position - aspirated ©Copyright Task Force Tips LLC 2002 - 2019 LKB-200 July 29, 2018 Rev01... -
Page 8: Drawings And Part Lists
DRAWINGS AND PART LISTS ©Copyright Task Force Tips LLC 2002 - 2019 LKB-200 July 29, 2018 Rev01... - Page 9 1.5" BUBBLE CUP CAP W/ TEETH F685 LABEL: BUBBLE CUP 20 & 60/95 FL83 CABLE - 6 POLE MALE IN-LINE PLUG Y5480 O-RING112 VO-112 SPRING WASHER F636 ©Copyright Task Force Tips LLC 2002 - 2019 LKB-200 July 29, 2018 Rev01...
-
Page 10: Warranty
7.0 WARRANTY Task Force Tips LLC, 3701 Innovation Way, Valparaiso, Indiana 46383-9327 USA (“TFT”) warrants to the original purchaser of its Twister and Bubble Cup series nozzles (“equipment”), and to anyone to whom it is transferred, that the equipment shall be free from defects in material and workmanship during the fi... -
Page 11: Flow Testing
Any returns should include a note as to the nature of the problem and whom to reach in case of questions. Repair parts and service procedures are available for those wishing to perform their own repairs. Task Force Tips assumes no liability for damage to equipment or injury to personnel that is a result of user service. -
Page 12: Inspection Checklist
Operating a nozzle that fails any of the above inspections is a misuse of this equipment. TASK FORCE TIPS LLC 3701 Innovation Way, Valparaiso, IN 46383-9327 USA 800-348-2686 • 219-462-6161 • Fax 219-464-7155 MADE IN USA • tft.com ©Copyright Task Force Tips LLC 2002 - 2019 LKB-200 July 29, 2018 Rev01...
Need help?
Do you have a question about the ER Bubble Cup and is the answer not in the manual?
Questions and answers