Table of Contents
Advertisement
Operating Instructions & Parts Manual
Ver. 2011-12-1
Assembly Instructions
STD=WFH BR=SW
For STD-181, STD-227, BR-159, BR-181, BR-227
Step 1: Connect the support legs to the main assembly by following below instructions
(1) Insert a support leg into each of the openings in the main assembly.
(2) One at a time, pull the retaining pegs to allow the legs to slide further into the openings.
(3) Slowly release the pegs. You may have to wiggle the leg to get the peg to drop.
(4) Pull upwards on each of the support legs to verify that they are held in place by the pegs. The
legs should not be able to slide out of the opening.
(5) If a leg comes out of the opening, the corresponding peg did not engage properly.
Page 9 / 27
Advertisement
Table of Contents
