Operating Instructions - BACKSAFE STURGO STD-181 Operating Instructions & Parts Manual

Operating Instructions & Parts Manual

Operating Instructions

Do Not Operate Unless:
You learn and practice the principles of safe machine operation contained in this operator's manual.
1. Avoid hazardous situations.
2. Always perform a pre-operation inspection.
3. Always perform function tests prior to use.
4. Inspect the workplace.
5. Only use the machine as it was intended.
Fundamentals
Using the machine for any purpose other than lifting material is unsafe.
If more than one operator is expected to use a machine at different times in the same work shift, each
operator is expected to follow all safety rules and instructions in the operator's manual. That means.
That means every new operator should perform a pre-operation inspection, function tests and a
workplace inspection before using the machine.
Setup
Select an area that is firm, level and free of obstructions.
Follow the Setup procedures in the Function Tests section.
Raising and Lowering load-Manual Winch
1. Center the load on the forks or load platform
2. Raise the load by firmly grasping the winch handle and rotating it clockwise. Do not allow the cable to
wind unevenly onto the winch drum.
3. Lower the load by firmly grasping the winch handle and rotating it counterclockwise. After lowering to
the desired position, turn the winch handle clockwise (raise the load)1/4 turn to set the brake.
Moving Machine with a Load
It is best to move the machine on the work site with no load. Moving a raised load should be restricted to
positioning for loading and unloading. If it is necessary to move the machine with a raised load,
understand and obey the following safety rules:
·Make sure the area is level and clear of obstructions
·Make sure the load is centered on the forks or load platform
·Avoid sudden starts and stops
·Travel with the load in the lowest possible position
·Keep personnel away from the machine and load
·Do not tilt the machine back with a raised load
Moving Machine on Stairs
It is best to move the machine on stairs using the optional stair glides. Moving the machine on stairs
without the use for stair glides is not recommended, If it necessary to move the machine on stair,
Page 16 / 27
Ver. 2011-12-1