Function Tests - BACKSAFE STURGO STD-181 Operating Instructions & Parts Manual

Hand stacker
Table of Contents

Advertisement

Operating Instructions & Parts Manual
Ver. 2011-12-1

Function Tests

Do Not Operate Unless:
You learn and practice the principles of safe machine operation contained in this operator's manual.
1. Avoid hazardous situations.
2. Always perform a per-operation inspection.
3. Always perform function test prior to use.
Know and understand the function tests before going on to the next section.
4. Inspect the workplace.
5. Only use the machine as it was intended.
Fundamentals
The Function Tests are designed to discover any malfunctions before the machine is put into service.
The operator must follow the step –by-step instructions to test all machine functions.
A malfunctioning machine must never be used. If malfunctions are discovered, the machine must be
tagged and removed from service. Repairs to the machine may only be made by a qualified service
technician, according to the manufacturer's specifications.
After repairs are completed, the operator must perform a pre-operation inspection and function tests
again before putting the machine into service.
FUNCTION TESTS
Select a test area that is firm, level and free of obstructions.
Setup
1. Tilt the machine back.
2. Slide each fork onto the carriage and secure it with the fork lock pins.
3. Slide each leg into a base socket until the leg lock pin snaps into the leg.
4. Stand the machine up.
5. Remove the winch handle, reverse the handle and install it. The handle grip should face the operator.
6. Straddle base: Adjust to desired width. Be sure the leg lock pin snaps into the leg.
7. Rotate the hold-down bar off of the carriage.
Load Platform
1. Lay the load platform onto the forks.
2. Lift the front of the load platform and push it toward the carriage until the back angle is under the lower
fork mounting tube.
3. Rotate the load platform down until it locks into place over the forks.
Test the Brake Operation (if equipped)
1. Press down on the food pedal to lock the brake.
2. Push the machine
Result:The wheels should not roll.
Page 14 / 27

Advertisement

Table of Contents
loading

Table of Contents