Table of Contents
Advertisement
Operating Instructions & Parts Manual
Load Capacity Charts
Observe and Obey:
1. Failure to properly position the load may result in death or serious injury.
2. Verify that the load you wish to raise does not exceed the maximum load for your load center. See the
load capacity charts on the next page.
WARNING: Tip-over hazard: Raising a load that exceeds the machine capacity may result in death of
serious injury. 3. A load center is defined as the balancing point (center of gravity) of a load and must be
positioned within the load center zone.
WARNING: Tip-over hazard: Failure to position the load center within the load center zone may result in
may death or serious injury.
Forks
Load Positioning Instructions
1. Determine the weight of the load and the location of its load center.
2. Measure to the load center from the side of the load that will be closest to the carriage.
3. Refer to the chart on the next page to determine if the machine is capable of lifting the weight at the
location on the fork.
4. Place the load so that it rests on the forks, as close to the carriage as possible.
5. Position the load so that the load center is within the load center zone.
Forks Load Capacity Chart
Model
STD-181
STD-227
STD=WFH
BR-159
BR=SW
BR-181
BR-227
BC-159
BC-181
BC-227
Maximum Load Centers (measure from front of carriage)
Forks:
Load Platform:
cm
25.4
kgs
181
kgs
227
kgs
159
kgs
181
kgs
227
kgs
159
kgs
181
kgs
227
30.5cm
30.5cm
30.5
159
204
136
159
204
136
159
204
Page 18 / 27
Ver. 2011-12-1
Advertisement
Table of Contents
