AirLive WIAS-1000G Manual
  1. Manuals
  2. Brands
  3. AirLive Manuals
  4. Wireless Router
  5. WIAS-1000G
  6. Manual

AirLive WIAS-1000G Manual

How to deploy console cable to connect to pc, to reset setting or check status via console
Hide thumbs
1
2
3
4

Advertisement

Table of Contents

How to deploy console cable to connect WIAS-1000G and PC, to reset setting or check
status via console
WIAS-1000G provides function to reset password or default setting via console port, the following steps to guide you
the process.
WIAS-1000G console port is RJ-11, and there is a RJ-11 to RS-232 cable including in the packing.
This is the outlook of cable
Before to run Windows Hyper terminal program, you should connect WIAS-1000G and your PC with cable. Just plug
RJ-11 to WIAS-1000G console port, and RS-232 to your PC serial port, then to follow the steps to configure Hyper
Terminal and enter WIAS-1000G to access the command via console port.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WIAS-1000G and is the answer not in the manual?

Questions and answers

Related Manuals for AirLive WIAS-1000G

Summary of Contents for AirLive WIAS-1000G

  • Page 1 Before to run Windows Hyper terminal program, you should connect WIAS-1000G and your PC with cable. Just plug RJ-11 to WIAS-1000G console port, and RS-232 to your PC serial port, then to follow the steps to configure Hyper Terminal and enter WIAS-1000G to access the command via console port.
  • Page 2 Enter key to make selection or confirm what you enter. 3. Once the console port of WIAS-1000G is connected properly, the console main screen will appear automatically. If the screen does not appear in the terminal simulation program automatically, please try to press the arrow keys, so that the terminal simulation program will send some messages to the system and the welcome screen or the main menu should appear.
  • Page 3 Utilities for network debugging The console interface provides several utilities to assist the Administrator to check the system conditions and to debug any problems. The utilities are described as follow: Ping host (IP): By sending ICMP echo request to a specified host and wait for the response to test the network status.
  • Page 4 Although it does not require a username and password for the connection via the serial port, the same management interface can be accessed via SSH. Therefore, we recommend you to immediately change the WIAS-1000G Admin username and password after logging in the system for the first time.

Table of Contents