Adjustment Condition - Icom IC-208H Adjustment Procedure

SOFTWARE ADJUSTMENT-Continued
ADJUSTMENT
FREQUENCY 1 • Operating frequency
DEVIATION • Connect an audio generator to the [MIC] jack and set
(VHF band) as
[DE] • Connect an FM deviation meter to the antenna con-
nector and set as :
HPF
LPF
De-emphasis
Detector
• Transmitting
2 • Operating frequency
• Transmitting
(UHF band) 3 • Operating frequency
[DE] • Transmitting
4 • Operating frequency
• Transmitting
DTCS WAVE 1 • Operating frequency
FORM • No audio signal is applied to the [MIC] jack.
• DTCS code
(VHF band)
[DE] • Set an FM deviation meter as:
HPF
LPF
De-emphasis
Detector
• Transmitting
(UHF band) 2 • Operating frequency
• Transmitting
[DE]
TRACKING 1 • Operating frequency
(Low band) • Connect an SSG to the antenna connector and set as
[Tr] Level
Modulation
Deviation
• Receiving
2 • Operating frequency
• Receiving
3 • Operating frequency
• Receiving
4 • Operating frequency
• Receiving
(Middle1 5 • Operating frequency
band) • Connect an SSG to the antenna connector and set as
[Tr] Level
Modulation
Deviation
• Receiving
• Operating frequency
6
• Receiving
7 • Operating frequency
• Receiving
8 • Operating frequency
• Receiving
*This output level of a standard signal generator (SSG) is indicated as SSG's open circuit.

ADJUSTMENT CONDITION

: 144.0 MHz
: +20 dB
: 50 Hz
: 20 kHz
: OFF
: (P–P)/2
: 148.0 MHz
: 440.0 MHz
: 450.0 MHz
: 146.0 MHz
: 007
: OFF
: 20 kHz
: OFF
: (P–P)/2
: 445.0 MHz
: 118.1 MHz
: 1 µV* (–107 dBm)
: 1 kHz
: ± 3.5 kHz
: 146.1 MHz
: 160.1 MHz
: 173.9 MHz
: 230.1 MHz
: 1 µV* (–107 dBm)
: 1 kHz
: ± 3.5 kHz
: 260.1 MHz
: 380.1 MHz
: 399.9 MHz
• Turn the [DIAL] to set to ±4.6 kHz.
• Push the [BAND] key.
• Turn the [DIAL] to set to ±4.6 kHz.
• Push the [BAND] key.
• Turn the [DIAL] to set to ±4.6 kHz.
• Push the [BAND] key.
• Turn the [DIAL] to set to ±4.6 kHz.
• Push the [BAND] key.
• Turn the [DIAL] to set to flat wave form as shown
below.
• Push the [BAND] key.
• Turn the [DIAL] to set to flat wave form as same as
VHF band.
• Push the [BAND] key.
• Push the [BAND] key.
• Push the [BAND] key.
• Push the [BAND] key.
• Push the [BAND] key.
• Push the [BAND] key.
• Push the [BAND] key.
• Push the [BAND] key.
• Push the [BAND] key.
8
OPERATION
Set to square wave
form