Wickes CDT212W.4 Original Instruction page 12

D) HOW TO CHARGE YOUR BATTERY PACK (See Fig. A3)
CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet, the green
LED will light.
2) Slide the battery pack into the charger, the red LED will
light to indicate that charging has started.
3) When charging has completed, the green LED will
light. The pack is now fully charged, unplug the charger
and remove the battery pack.
WARNING: If the battery pack is warm e.g. after
continuous use or after exposure to direct sunlight or
heat, allow time to cool down before re-charging to
achieve the full charge.
Light
Red on
Green on
OPERATION
1. ON / OFF SWITCH (See Fig. B)
Depress the On/Off switch (8) to start and release it to
stop your drill. The on/off switch (8) is fitted with a brake
function which stops your chuck immediately when you
quickly release the switch.
It is also a variable speed switch that delivers higher
speed and torque with increased trigger pressure.
Speed is controlled by the amount of On/Off switch (8)
depression.
2. SWITCH LOCK
The On/Off switch (8) can be locked in the OFF position. This helps to reduce the possibility of accidental starting when not
in use. To lock the On/Off switch (8), place the rotation control (4) in the center position.
Fig. A3
Status
Charging
Fully Charged
Fig. B
12