Troubleshooting - Wickes CDT212W.4 Original Instruction

10. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve the load on the machine immediately and allow cooling for approx.
30 seconds at the highest no-load speed.
11. TEMPERATURE DEPENDENT OVERLOAD PROTECTION
This power tool has over-load protection built in. If the load is too high or the battery temperature exceeds 75°C, the
electronic control switches off the power tool until the battery has cooled.
12. PROTECTION AGAINST DEEP DISCHARGING
The Li-ion battery is protected against deep discharging by the "Discharging Protection System". When the battery is
empty, the machine is switched off by means of a protective circuit: The inserted tool no longer rotates.

TROUBLESHOOTING

1. WHY DOES THE DRILL NOT TURN WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is on top of the switch, is positioned in the lock function. Unlock the forward/
reverse rotation control by putting it into the required rotation position. Push the On/Off switch and the drill will start to
rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring, you can find the torque-adjusting ring between the chuck and the
drill body. Position 1 is the lowest torque (screw driving force) and position 18 is the highest torque (screw driving force).
Position is for drill operation. Regulate the torque adjusting ring to a higher position to reach the best result.
3. REASONS FOR DIFFERENT BATTERY PACK WORKING TIMES
Charging time problems, as above, and having not used a battery pack for a prolonged time will reduce the battery pack
working time. This can be corrected after several charge and discharge operations by charging & working with your drill.
Heavy working conditions such as large screws into hard wood will use up the battery pack energy faster than lighter
working conditions. Do not re-charge your battery pack below 0 C and above 45 C as this will affect performance.
o o
15