Connectivity; Wired Connectivity; Notes On Using Wired Lan - Panasonic TH-86SQE1W Operating Instructions (Functional Manual)

HDMI cable. When inputting video signals exceeding
the transmission speed supported by the HDMI
cable you are using, malfunction may occur such as
interrupted pictures and no display on the screen.

Connectivity

To configure wired or wireless settings you should
access the Network menu in the Settings menu.

Wired Connectivity

To Connect to a Wired Network
• You must have a modem/router connected to an
active broadband connection.
• There is a LAN port at the bottom of the rear side of
your Display. Connect your Display to your modem/
router via this LAN port using an Ethernet cable.
3
Broadband ISP connection
1
LAN (Ethernet) cable
2
LAN input on the bottom of the rear side of the
3
Display
Configuring Wired Device Settings
Network Type
Set the Network Type as Wired Device if you are
connecting via an Ethernet cable.
Internet Speed Test
Highlight Internet Speed Test and press the ENTER
button. Display will check the internet connection ban-
dwidth and display the result when complete.
Advanced Settings
Highlight Advanced Settings and press the ENTER
button. On the next screen you can change the IP and
DNS settings of the Display. Highlight the desired one
and press Left or Right button to change the setting
from Automatic to Manual. Now you can enter the
Manual IP and / or Manual DNS values. Select the
related item in the drop down menu and enter the
new values using the numeric buttons on the remote.
Highlight Save and press the ENTER button to save
settings when complete.
1
2
Other Information
You can also enable or disable Wake On feature using
the related option. The status of the connection will
be displayed as Connected or Not Connected and
the current IP and MAC addresses, if a connection is
established.
Wireless Access Point
If the network type is set as Wired Device access point
feature will be available. Highlight Access Point option
and press ENTER. Access Point, SSID, Security Type
and Password options will be available.
Access Point: Start or stop access point functionality.
The function of this option will change according to the
current status.
SSID: Set the name of the accesspoint.
Security Type: Secure your network using WPA2 PSK.
You can also set this option as None. In that case no
password will be required to connect to the access point.
This option can be set only if the access point feature
is not activated.
Password: Define a password for the access point.
This option will be available if the Security Type option
is set as WPA2 PSK and can be set only if the access
point feature is not activated.
Notes on Using Wired
LAN
When setting up the Display at a place, where ele-
ctric statistic occurs often, take a sufficient antista-
tic measure before start using.
• When the Display is used at a location, whe-
re static electricity occurs often, such as on a
carpet, a wired LAN communication is discon-
nected more often. In that case, remove static
electricity and the noise source that may cause
problems with an antistatic mat, and re-connect
the wired LAN.
• In rare cases, the LAN connection is disabled
due to static electricity or noise, In that case,
turn off the power of the Display and the con-
nected devices once and then re-turn on the
power.
The Display may not work properly due to strong
radio wave from the boardcast station or the ra-
dio.
• If these is any facility or equipment, which out-
puts strong radio wave, near the installation
location, set up the Display at a location suffi-
ciently far from the source of the radio wave.
Or wrap the LAN cable connected to the LAN
terminal by using a piece of metal foil or a metal
English - 31 -