Push On Valve; Compression Fitting; Flexible Hoses - Lindab Plexus Installation Instructions Manual

l i nd ab | we s im pli fy co ns t r uc t io n
Installation instruction
4.1.2 Push-on valve
• Mount a push-on valve to the pipe. Make sure the valve has the correct flow direction (see indication arrow on the valve) and
that you have the correct valve, when integrated valve has been chosen (see indication on valve or follow cabelling to Regula
Connect card). Cooper inserts aren't required !
• Please refer to the suppliers manual.

4.1.3 Compression fitting

• While mounting a compression fitting, the pipe will be exposed to a big amount of force, creating a risk of crushing the pipe.
To ensure that the pipe won't be crushed when mounting the compression fitting, a copper insert must be inserted into the
pipe (always part of the delivery).
• The copper insert should be placed inside the pipe on the beam. Always support the copper pipe coil when inserting the
copper insert into position.
• Mount a compression coupling and/or a valve to the pipe. Don't stress the nut too much, since this may crush the pipe.
• Please refer to the suppliers manual.

4.1.4 Flexible hoses

• Our flexible hoses with straight ends can be used with both push-on and compression fitting.
• We recommend to use our flexible hoses with push-on fittings, for easier and faster mounting.
• For the connection to an enclosed valve with integrated push on coupling a flexible hose with straight end (male) or with push
on (female) and a short copper pipe can be used.
• Please refer to the suppliers manual.
* L = 70 mm (to ensure you can open the couplings again).
min
Lindab flexible hoses are available with straight end (male) for direct connection to Lindab valves also.
12
L *
min
Lindab reserves the right to make changes without prior notice
2021-03-02
Plexus