Table of Contents
Advertisement
USER GUIDE
5.
CONNECTING TO VIDEO
Video connects through different interfaces, depending on the type of
equipment and quality level of the video signal.
VIDEO. This is the most frequently used video connection. Use
the A/V cable to connect between the yellow phono connectors
on the video source and the projector.
The A/V cable also provides connection to stereo sound.
Connect the cable between the red and white phono
connectors on the video source and the AUDIO IN VIDEO
connector on the projector.
S-VIDEO. Connect the S-video cable between the S-VIDEO
connector on the video source and the projector. S-VIDEO
should give a better quality image than VIDEO.
Connect sound as described above.
SCART ADAPTER. Some video sources are provided with the
SCART connector for video and audio output. The SCART
adapter (supplied in Europe) provides connection to the A/V
cable.
RGB VIDEO. Some high end video sources have component
red, green and blue video outputs for a best possible image.
Some systems use BNC type connectors, other systems use
the older CGA or the VGA connector. Contact your dealer for
an adapter that is suitable for your source. Use the cable for
stereo sound connection.
6.
MAINS POWER.
Connect the mains cord to the projector and all other equipment in the
set-up. Please wait for 10 seconds, or until the POWER button shines a
stable yellow light, before you switch on.
7.
SWITCH ON by using the POWER button on the projector or the
remote control. It is important to switch the projector on first in order for
correct detection of the projector as a display and mouse peripheral
device to the computer.
XGA LCD PROJECTOR
15
Advertisement
Table of Contents
