Table of Contents
Advertisement
7.
Do not use flammable substances in the vicinity of unshielded flames or ignition
sources.
Engines, electric devices and controllers may create electric arcs capable of igniting flam-
mable gases or vapour. Do not store flammable liquids, gases or other substances in the vi -
cinity of the paint sprayer.
8.
Always ensure that fire-fighting appliances are available and fully functional.
9.
Keep the pump away from the spray zone in order to avoid contact with solvents and paint
fumes.
10.
Only use the paint sprayer with water based or mineral materials.
11.
Do under no circumstances use bleach, naphthalene, acetone, alcohol or toluol in order to
clean the device or its accessories.
12.
Never use solvents with a combustion point below 21°C in order to clean devices. Such
solvents may cause explosions. Examples for suitable detergents are water, turpentine and
paint thinner. Please note that some of these detergents might be unsuitable for certain types
of colours.
13.
Abide by the security instructions and information provided by the manufacturer of the sub-
stances and detergents used.
14.
Keep the hose away from sharp edges, since leaking or bursting hoses might lead to severe
injuries. Regularly check the hose to ensure its integrity and immediately replace it, if it should
be damaged or show signs of wear.
15.
Always use the lowest air pressure setting when rinsing the paint sprayer.
16.
All hoses and components of the paint sprayer need to at least be able to resist a minimum
pressure of 206.84 bar (3000 PSI).
17.
The paint sprayer has to be connected to a socket-outlet that has been earthed in accordance
to the local regulations and prescriptions.
18.
Be careful when using this device on windy days.
19.
Do not use the device without nozzle head protection or spray pistol.
20.
Clean the device after each use in order to prevent permanent damage and to thereby prolong
its service life.
21.
The casing of the device heats up during operation. Do not touch its casing before it has
cooled down entirely.
22.
Remove the nozzle or set it to its cleaning position before cleaning or rinsing the device.
23.
Do not use pliers to fasten or loosen high pressure connections.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Artikel 62567
Seite 6
09
2020-1
Advertisement
Table of Contents
