WilTec 62567 Operation Manual page 17

Remove the suction pipe from the water/solvent and place it inside a paint bucket

Once again turn on the device.

The paint should travel from the suction pipe through the sprayer and to the intake pipe until

paint leaks from the same. Point the spray gun and activate it by pressing the trigger.
Set the mode selector switch to spray mode and continue spraying into the bucket.

© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Artikel 62567 Seite 17
09 2020-1