WilTec 62567 Operation Manual page 18

Stop spraying and lock the trigger with help of the release lock.

Remove the intake pipe from the bucket and clip it to the suction pipe. Then place both inside

the paint bucket.
Once the pump and tubes have been primed, the motor will stop. If the motor, however, does

not stop, then the priming steps have to be repeated.
Start painting.

Painting
Before beginning the paintwork, ensure that the paint sprayer and its spray gun have been prepared
according to the instructions within this operation manual.
Note: Remove or at least cover objects that you wish to protect from paint splatter and paint mist.
The distance between the spray gun and the surface you wish to paint should approximately be 30
cm.
A. Once the priming process has been completed, set the nozzle to spray position.
B. Start spraying with the lowest pressure setting. If necessary, slowly increase the pressure by
turning the pressure control button clockwise in order to create a sufficient spray pattern.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Artikel 62567 Seite 18
09 2020-1