Modification Of The Speed Setting; Modification From The Current Speed; Modification Of The Programmed Inter-Vehicle Distance - CITROEN C4 Spacetourer Handbook

Driving
The driver should press the accelerator pedal
to move off, then reactivate the system above
19 mph (30 km/h) by pressing button 2, 3 or 4.
If the driver takes no action following this
immobilisation, the electric parking brake is
applied automatically after a while (approx. five
minutes).
As a safety measure, wait until the current
speed approaches the speed setting to
reactivate the function by pressing button 4.
Modification of the speed
setting
With the engine running and cruise control on
(green), you can modify the speed setting.
Modification from the current
speed
F By successive short presses on button 2 or
3, to lower or raise the setting in steps of +
or – 1 mph (km/h),
F By a maintained press on button 2 or 3, to
lower or raise the setting in steps of + or –
5 mph (km/h).
160
Take care: pressing and holding button
2 or 3 results in a rapid change in the
speed of your vehicle.
Modification from the
Speed Limit recognition and
recommendation system
F The suggested speed is displayed in the
instrument panel.
F Make an initial press on button 5; a
message is displayed to confirm the
memorisation request.
F Press button 5 again to save the suggested
speed.
The speed displays immediately in the
instrument panel as the new speed setting.
For more information on the Speed Limit
recognition and recommendation, refer to
the corresponding section.
As a precaution, it is recommended
that you select a cruise speed close to
the current speed of your vehicle, so
as to avoid any sudden acceleration or
deceleration of the vehicle.
Modification of the programmed
inter-vehicle distance
Three threshold settings are suggested for the
inter-vehicle distance:
- "Distant" (3 dashes),
- "Normal" (2 dashes),
- "Close" (1 dash).
Engine running and with the wheel at the
"CRUISE" position:
F Press button 6 to display the selection
screen for inter-vehicle distance.
F By pressing button 6 repeatedly, cycle
through the predefined settings.
The selection screen closes after a few
seconds.
The modification is then accepted.
This setting remains in memory, whatever the
state of the system and when the ignition is
switched off.
The selection also applies to the stopping
distance (versions with EAT6 and
EAT8 automatic gearbox).