Cushion Height And Angle; Storing Driving Positions; Head Restraint Height; Removing A Head Restraint - CITROEN C4 Spacetourer Handbook

Cushion height and angle

F Tilt the rear part of the control upwards or
downwards to obtain the required height.
F Tilt the front part of the control upwards or
downwards to obtain the desired angle.

Storing driving positions

System which registers the electrical settings
of the driver's seat.
Two positions can be stored and recalled, using
the buttons on the side of the driver's seat.
Storing a position using buttons
M/1/2
F Switch on the ignition.
F Adjust your seat.
F Press button M, then press button 1 or
2 within four seconds.
An audible signal indicates that the position has
been stored.
Storing a new position overwrites the previous
position.
Recalling a stored position
F With the ignition on or the engine
running, press button 1 or 2 to recall the
corresponding position.
An audible signal indicates the completion of
the adjustment.
You can interrupt the current movement by
pressing button M, 1 or 2 or by using one of the
seat controls.
A stored position cannot be recalled while
driving.
Recalling stored positions is deactivated
45 seconds after switching off the ignition.
Ease of use and comfort
Additional adjustments

Head restraint height

F To raise a head restraint, pull it upwards.
F To lower the head restraint, press the lug A
and push down on the head restraint at the
same time.
The head restraint has a frame with notches
which prevents it from lowering; this is a safety
device in case of impact.
The adjustment is correct when the
upper edge of the head restraint is
level with the top of the head.

Removing a head restraint

F To remove the head restraint, press the lug
A and pull the head restraint upwards.
F To put the head restraint back in place,
engage the head restraint stems in the
openings, keeping them in line with the seat
backrest and press the lug A at the same
time.
3
59