Spare Wheel; Access To Tooling - CITROEN C4 Spacetourer Handbook

F Uncoil the pipe stowed under the
compressor.
F Screw the pipe onto the valve and tighten
firmly.
F Check that the compressor switch is at the
"O" position.
F Uncoil fully the electric cable, stowed under
the compressor.
F Connect the compressor's electric plug to
the vehicle's 12 V socket.
F Switch on the ignition.
Only the 12 V socket located at the front
of the vehicle can be used to power the
compressor.
The tyre inflation pressures are given on
this label.
F Start the compressor by placing the switch
at position "I" and adjust the pressure to the
value shown on the vehicle's tyre pressure
label. To deflate: press the black button
located on the compressor pipe, near the
valve connection.
If a pressure of 2 bars is not reached after
7 minutes, this indicates that the tyre is
not repairable; contact a CITROËN dealer
or a qualified workshop for assistance.
F Once the correct pressure is reached, put
the switch to the "O" position.
F Remove the kit then stow it.
Do not drive more than 125 miles (200 km)
with the repaired tyre; see a CITROËN
dealer or a qualified workshop to change
the tyre.
Should the pressure of one or more tyres
be adjusted, it is necessary to reinitialise
the under-inflation detection system.
For more information on Tyre under-
inflation detection, refer to the
corresponding section.
In the event of a breakdown

Spare wheel

Procedure for changing a wheel with
a damaged or punctured tyre for the spare
wheel using the tools provided with the vehicle.
Scan the QR code on page 3 to view
explanatory videos.

Access to tooling

The tools are installed in the boot under the
floor.
Remove the boot carpet to access them.
8
211