Set Heating Time; Overheating Protection - Silvercrest SKD 2300 D5 Operating Instructions Manual

Set heating time

The appliance has a timer that you can use to set the desired heating time between 1 to
24 hours. Once this period is over, the appliance switches off automatically.
♦ Press the Timer button
preset heating time
♦ While the hour display is flashing, press the arrow button
arrow button
♦ Press the Timer button
on the display
♦ While the minutes display is flashing, press the arrow button
arrow button
♦ Press the Timer button
now activated and the set heating time
♦ To turn off the timer, press the Timer button
and the set heating time

Overheating protection

The appliance is fitted with a thermostat-controlled overheating protector. If the appli-
ance becomes too hot internally, the heating element switches off automatically. As
soon as the appliance has cooled down, the heating element switches back on.
WARNING
As a general rule, there is a reason for overheating! It can mean a
risk of fire!
► Check that the appliance can sufficiently dissipate the heat generated: Is the
appliance covered or is it too close to a wall or other obstacle? Is the fan
blocked?
► Check that neither the air inlet
the cause.
► If possible, eliminate the problem or contact the Service Hotline (see the chap-
ter Service).
SKD 2300 D5
17
or . Timer appears on the display
18
of one hour flashes.
29
16
or to display the hours of the heating time
17
or to confirm the hours setting. The minutes flash
2
.
29
16
or , to set the minutes of the heating time
17
or to confirm the minutes setting. The timer is
18
on the display
5
nor the air outlet
15
18
is counted down.
17
or until the Timer display
2
go out.
3
is blocked and remove
2
and the
32
or or the
18
.
15 32
or or the
18
.
GB │ IE │
33 ■