INSTALLATION Uncrate carefully. Report any hidden freight damage to kettle is A.S.M.E. code stamped for operation to 50 the freight company immediately. PSI. Temperature range from 150° F to 285° F. 120 VAC, 1pH, 50/60 Hz Set unit in place. Be certain to maintain the following minimum clearances to combustible construction.
The total amount of distilled water in each kettle is: ever the main burner gas is on. • FT-20GL - 6 Gallons of water (AMBER) LOW WATER LIGHT - All kettles are supplied with sufficient distilled water in pressur- •...
MAINTENANCE PERIODIC MAINTENANCE pressure switch is found to be the problem. See NOTICE: As a safety precaution, disconnect the power “Pressure Switch” below. supply during cleaning or servicing. PRESSURE SWITCH: The pressure switch should not CLEANING be adjusted until it is determined to be the cause of an For easier cleaning add cold water to the kettle imme- operating pressure difficulty.
TROUBLE-SHOOTING MOTOR WILL NOT RUN! MOTOR RUNS, SPARK PRESENT SHORT FLAME! 1. Wrong Main Orifice. 1. No Current. ON GAS IGNITION! 2. Defective Thermostat. 2. Low Gas Pressure. 1. Manual Main Valve Off. 3. Defective Motor. 3. Air Shutter Adjustment. 2.
Need help?
Do you have a question about the FT-20GL and is the answer not in the manual?
Questions and answers