Table of Contents
Advertisement
Amplifier Top View
Refer to Figure 2
1.
Four 0.177" (4.5 mm) mounting holes
2.
FACTORY RESET – Insert a non-conductive tool
into the 0.188" (4.78 mm) FACTORY RESET hole
then press and hold the reset button for at least
3 seconds. This resets all network settings (IP
Address, host name, etc.) back to the factory
values.
3.
POWER OK – Green = OK
4.
AMPS OK – Green = OK
5.
DANTE OK – Green = OK
6.
FAN FAULT – Red = Fault
7.
Cooling Fan – System controlled on/off and speed.
Amplifier Bottom View
Refer to Figure 3
The serial number information for the unit is found on a
label on the bottom side of the amplifier.
TD-001622-01-A
1 (4x)
2
FACTORY RESET
3
POWER OK
4
AMPS OK
5
DANTE OK
FAN FAULT
6
7
10
— Figure 2 —
— Figure 3 —
Advertisement
Table of Contents
