Setting The Current Day And Time - Weinmann & Schanz Bellavista 90 847 89 User Instruction Manual

Press the "Mode" selection key until the icon
appears on the LCD.
This operating mode is recommended when no people is in
the room for more than 1 day.
4.2.5 CHRONO
In "Chrono" mode, you can select one of the three preset
chrono-thermostat programs or the custom program. The
latter lets you set various temperatures ("Comfort" and
"Night/Eco") over a 24 hour period for each day of the week.
CHOICE OF PROGRAM
Press the "Mode" key until the icon
played. Then press the "Mode" and "-" keys to-
gether and hold them both down for at least 3
seconds.
The program code (P1, P2, P3 and P4) flashes.
Press the "+" or "-" keys to set the program. Press
the "Mode" key to confirm.
The icon of the ASC function (see Ch. 4.3.1)
starts flashing. Press the
function or the "-" key to de-activate it.
PROGRAM P1
FROM MONDAY TO FRIDAY
SATURDAY AND SUNDAY
PROGRAM P2
FROM MONDAY TO SUNDAY
PROGRAM P3
FROM MONDAY TO FRIDAY
is dis-
key to activate the
HOURS MODE
0 - 6 Night/Eco
6 - 9 Comfort
9 - 16 Night/Eco
16 - 23 Comfort
23 - 0 Night/Eco
0 - 7 Night/Eco
7 - 23 Comfort
23 - 0 Night/Eco
HOURS MODE
0 - 7 Night/Eco
7 - 23 Comfort
23 - 0 Night/Eco
HOURS MODE
0 - 6 Night/Eco
6 - 9 Comfort
9 - 13 Night/Eco
13 - 23 Comfort
23 - 0 Night/Eco
SATURDAY AND SUNDAY
PROGRAM P4 - CUSTOM
With the "P4" program, you can set different temperatures
("Comfort" and "Night/Eco") over a 24 hour period for each
day of the week.

SETTING THE CURRENT DAy AND TIME

Before going on with the P4 custom program setup, check
that the hour and day of the week have been correctly set up.
If you fail to enter the setup in this way, press
the "Mode" key until the
the display.
Then press the "Mode" key again and hold
it down until the number indicating the day
flashes.
Adjust the day of the week by using the "+"
or "-" keys (1=MON, 2=TUE,...7=SUN), then
confirm by pressing the "Mode" selection key.
Repeat the same procedure for the hours.
The minutes now start flashing. Use the "+" or
"-" keys to set the minutes then press the
to confirm and exit or press the "Mode" key to
enter the P4 program setup.
SETTING THE P4 PROGRAM
To enter the P4 custom program setup, press the "MODE" key
when you finish setting the minutes (see SETTING THE CUR-
RENT DAY AND TIME).
The time bar will now flash and the clock will show the time
being programmed.
Start with the first day. Choose by means of the "+" or "-" keys,
for each hour, between the "Comfort" temperature (two
lines) and the "Night/Eco" temperature (single line).
T Night/Eco
Press the "Mode" key to confirm and repeat the same
procedure for each day of the week.
The weekly program is now set.
23
0 - 7 Night/Eco
7 - 23 Comfort
23 - 0 Night/Eco
icon appears on
T Comfort T Night/Eco
GB
key