Table of Contents
Advertisement
3. Installing the hardware
1) After installing the VisualTable driver and related program, connect the USB cable of the
VisualTable to a USB port at the rear of your PC.
Note: The VisualTable book scanner can only work in USB 2.0. Check whether your
Note
PC supports USB 2.0
2) To use the VisualTable, there is no need for any additional drivers. After connecting the USB cable
of the VisualTable to your PC's USB port, wait a few seconds, and then a message appears as
"Your device is ready to use."
- 11 -
II_Installation
Advertisement
Table of Contents
Need help?
Do you have a question about the VisualTable RF-4730964 and is the answer not in the manual?