Structure Diagram; Prior To First Use; Operation - Monzana DBES001 Instructions Manual

Structure diagram

1 – Pusher
2 – Top cap/ Cover
3 – Juicing sieve
4 – Center ring
5 – Spout
6 – Motor wheel
7 – Lid
8 – Juice container
9 – Main Body
10 – Clamp
11 – Rotary switch
12 – Power Cord with plug
13 – Pomace container
14 – Safety switch

Prior to first use

Before using for the first time, or after prolonged
storage without use, wash any parts that will
come into contact with food. Ensure that you do
not injure yourself on the sharp blade.

Operation

Assembly before use
Place the motor section on a flat surface, e.g.
a kitchen counter and make sure it is standing
firmly on the suckers underneath. Ensure that
the switch on the appliance is set to „0".
Place the base on the motor section so that the
spout fits in the slot on the side of the motor
section.
Place the lid on the appliance and make sure that
it engages the lid and locks it fast.
Turn the lock mechanism and make sure that
it engages the lid and locks it fast. The lock
mechanism makes a clicking sound when this is
done correctly.
Place the pomace container side intended for
this purpose on the motor block.
www.Deuba24online.de
Place the juice container below the spout and
then place the lid on the juice container. The
opening inside the lid must enclose the spout.
Connect the appliance via the power cable to the
power supply.
The appliance is now ready for use.
Preparing fruits and vegetables for juicing
• Always wash fruits and vegetables thoroughly
before juicing.
• It is not necessary to remove seeds, pits or thin
peels before using the appliance.
• Fruits with thick peels such as oranges and
lemons must be peeled before juicing. It is
particularly
important to remove all the peel (including the
pith), as even small amounts of peel can impart
an unpleasant taste to the juice.
10 11 www.Deuba24online.de
• It is also necessary to remove large pits (such
as plum and apricot pits) to avoid damaging the
appliance. Large fruits and vegetables should be
cut into pieces that can fit into the funnel.
Use
Tip:
Push down the pusher slowly and with little
pressure in order to generate as much juice
as possible. Too much pressure can cause the
centrifugal screen to stop and damage the juicer.
A low number of revolutions ensures a high juice
quality. The less oxygen is entrained, the more
healthier is the juice. In addition, there is less
heat generation. For this reason, we recommend
using the slow course for fruits with a high
proportion of juice.
Start the appliance by turning the on/off button
to position "1" (low speed) or position "2" (high
speed). The low speed setting is suitable for
juicing soft fruits and vegetables. The high speed
setting is suitable for juicing harder fruits and
vegetables.
Position "P": rapid and momentary rotation as
pulse-function. Turn the switch counterclockwise
to position P. Hold the switch to use the function.
Feed the selected fruits and/or vegetables into
the appliance through the funnel a little at a
time, pushing them down using the tamper.
Make sure that you turn the tamper so that the
groove in the tamper into the funnel properly.