BKDM-3010
6-7. Installation of Track Ball
6-7. Installation of Track Ball
The track ball is not installed in BKDM-3010 at the factory.
Install the track ball according to the following procedures.
(1) Turn the ball cover counterclockwise and loosen it, then remove.
(2) Catch the Z-ring on a nail, raise it, then remove.
(3) Put a track ball in the position shown in the illustration.
(4) Push in the Z-ring while pressing it against the Z sensor plate.
(5) Turn the ball cover clockwise and tighten it.
Track ball
6-6
Tighten
Loosen
Z-ring
Z sensor plate
Ball cover
Z-ring
Track ball
Z sensor plate
Track ball
Z-ring
Z sensor plate
HDS-7150/7100