Advertisement
900TS0X_0R
4. Press the 'Initial settings...' button (marked green in Fig. 3).
Fig. 3
5. In the pop-up window that appears (Fig. 4) press the 'Yes' button:
Fig. 4
The touchscreen will then be restored to Factory settings; the software will be cleared and the IP-address
will automatically be modified the shown default value.
NOTE
After you have completed this procedure, ensure to program the desired touchscreen firmware from
your Project folder on the Web Portal (see Chapter 1).
NOTE
Restore the IP-address to the applicable IP-address via the Internet screen
(also see the 900TS Manual).
ebm-papst Heating Systems BV
900TS_Programming and Troubleshooting.doc
Programming and troubleshooting
ebm-papst – Commercial Plus
2019/04/11
Page 10 of 14
Advertisement
