Installation - BOMANN VS 2195 Instruction Manual

Installation

Installa Installa Installa
Conditions for the installation location Conditions for the installation location
Conditions for the installation location Conditions for the installation location
• Good ventilation is required around the appliance
to dissipate the heat properly and to guarantee ef-
ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
Gap to the back and to the side walls each ap-
-
prox. 10 cm;
Place the appliance so that the appliance door
-
can open without being impeded.
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to the "EU Product Data Sheet" or to the rating la-
bel located in the interior or on the appliance rear.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installa Avoid the installation: Avoid the installa Avoid the installa tion: tion: tion:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Assembling the rubber supporting pad Assembling the rubber supporting pad
Assembling the rubber supporting pad Assembling the rubber supporting pad
CAUTION: : : : CAUTION CAUTION CAUTION
Under extreme circumstances, there is a risk that the
appliance may tilt forward.
NOTE: : : : NOTE
NOTE NOTE
Installation of the rubber supporting pad is ONLY
necessary if the interior is empty and the refrigerator
door is loaded with 15 kg or more.
tion tion tion
ONLY ONLY ONLY
Tilt the appliance slightly back and block it in this
position. Use the delivered screw to secure the sup-
porting pad into the hole provided on the underside
of the door.
Electrical connection Electrical connection
Electrical connection Electrical connection
WARNING: WARNING: WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock! shock
shock shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
• Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Revers Reversing Revers Revers ing the door opening ing ing the door opening the door opening the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING: WARNING:
WARNING: WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
17
electric electric electric