3Com 3C16080 User Manual page 25

Command Line Interface 3-13
SLIP Address
To change the SLIP address, type SLIPA followed by a space and
the SLIP address assigned to the Management Module.
Use the format a.b.c.d, where a, b, c and d are numbers between
0 and 255. If you type a number that is not in this range, an error
message appears. The default SLIP address is 192.168.101.2.
If you do not know the SLIP address to use, contact your network
administrator.
Press [Enter] to save the new setting.
SLIP Mask
To change the SLIP mask value, type SLIPM followed by a space
and the SLIP mask value.
Use the format a.b.c.d, where a, b, c and d are numbers between
0 and 255. If you type a number that is not in this range, an error
message appears. The default SLIP mask is 255.255.255.0 .
If you do not know the SLIP mask value to use, contact your
network administrator.
Press [Enter] to save the new setting.
For these addresses to become effective, the module must be
reset using the RESET command. You are recommended to log on
to the Management Module again to ensure that the new
addresses are correct.
Trap Destination
Traps occur on power-up of the Management Module and on any
change of state of the RPS modules. Any SNMP Traps are sent to
the specified address.
DUA1608-0AAA01