Assembly Of The Meat Grinder; Assembly Of The Sausage Attachment; Mounting Of The "Kebbe" Attachment; Electrical Connection - Profi Cook PC-FW 1173 Instruction Manual

Assembly of the Meat Grinder

NOTE:
The design of the perforated disks represents a firmly
connected unit. This should not be loosened under any
circumstances.
• Please also observe our illustrations under "A" (Page 4).
• Please follow points 1 to 4 as described under "Prepa-
ration".
5. Insert the knife with the sharpened edge outwards onto
the shaft of the scroll.
6. Select a perforated disc (10). Use the recesses to do so.
7. Rotate the catch clockwise.
More details can be found under "Electrical connection" &

"Operation".

Assembly of the Sausage Attachment

• Please also observe our illustrations under "B" (Page 4).
• First proceed as described under "Preparation" and
"Assembly of the Meat Grinder", points 1 to 6.
7. Position the sausage attachment on the spiral housing.
8. Rotate the catch clockwise.
More details can be found under "Electrical connection" &
"Operation".

Mounting of the "Kebbe" Attachment

• Please also observe our illustrations under "C" (Page 4).
• Please follow points 1 to 4 as described under "Prepa-
ration".
5. Position the 2-piece Kebbe attachment on the shaft of
the spiral. Use the recesses to do so.
6. Rotate the catch clockwise.
More details can be found under "Electrical connection" &
"Operation".

Electrical Connection

1. Check whether the mains voltage that you want to use,
corresponds with that of the appliance. You will find the
information about it on the rating plate.
2. Ensure that the function switch is set to " " (Off).
3. Only connect the appliance to a properly installed safety
socket.
PC-FW1173_IM

Switch Functions

Function Switch ON / R (On / Return)
Use the switch (3) to select the desired operating mode for
the switch (2).
Switch ON / / R (Forward / Off / Return)
The appliance is equipped with a forward and return
function. If the scroll should block, you can use the return
function, in order to release it.
- Forward
• Turn the switch (3) to "ON".
• Turn the switch (2) to "ON". The appliance is in the
"Forward" mode.
- Return
• Turn the switch (2) to " " nd wait until the motor
stops.
• Turn the switch (3) to "R". Press "R" on the switch (2).
The appliance will be in the "Return" mode as long as
you keep the switch pressed down.
- Switching Off
• Move the switch (2) to " " and pull the power plug.
Operation
WARNING: Risk of injury!
Always use the supplied tamper. Never insert your fingers
or tools into the filling neck!
CAUTION:
Do not use the appliance for longer than 10 continuous
minutes. Let it cool for 10 minutes before using it again.
1. Put the pieces of meat (meat paste / sausage mass or
dough) on the filling tray and into the filler neck.
2. Stuff, if necessary, the meat respectively the dough with
the tamper (7).
Ending Operation
1. Disconnect the power plug.
2. Disassemble all parts of the meat grinder.
3. Clean the parts used as described under "Cleaning".
39
20.12.18