Qu-Bit Electronix Data Bender Manual page 15

• Bend disabled
• Break disabled
• Freeze disabled
• Mode to Macro Mode
• Stereo behavior to shared mode.
• Gates to Latching
• Break Jack set to primary function (not reset/sync).
• Freeze button behavior to latching mode
Gate Behaviors
While holding shift, the Freeze LED will indicate whether the gates are configured as mo-
mentary or latching.
Pressing the button while holding shift will toggle between the two options.
When the LED is blue the gates are latching (each trigger input will toggle the state of the
gated controls). When the LED is green the gates are momentary (an incoming gate signal
will hold the state of the button on if it is off, as long as it is held high).
Stereo Behavior
While holding shift, the Bend LED will indicate the stereo behavior of the macro-mode con-
trols.
Pressing the Bend button will toggle between these modes:
• Blue - Unique Mode: All automatic bend/break settings will be unique for each stereo
channel.
• Green - Shared Mode: All automatic bend/break settings are set the same for both
stereo channels.
Corrupt As Reset
While holding shift the corrupt LED will indicate whether the corrupt Gate input jack is con-
figured as normal (blue), or as a reset input (green).
When configured as a reset jack, the corrupt input will cause the internal or external clock
to resync.
15