Mode; Shift; Audio Inputs; Audio Outputs - Qu-Bit Electronix Data Bender Manual

If the module has not received an external clock for at least four beats (one measure) at
the last recorded clock rate, the LED will illuminate a DIM white to indicate that there is no
clock source present.
While there is no clock source, the clock will continue to run at the last rate until a new clock
pulse is detected.

9. Mode

Selects between Macro mode (Blue) and Micro mode (Green).
These modes are described below, and change the way the Bend and Break controls work.

10. Shift

Used for Secondary functions, and additional features. When held, the controls listed below
will perform their secondary actions.
Illuminates Blue when held.
• SHIFT + Time Knob - Glitch Windowing
• SHIFT + Bend Button - Stereo Behavior
• SHIFT + Break Button - Restore Settings
• SHIFT + Corrupt Button - Corrupt Jack as Reset Input
• SHIFT + Freeze Button - Freeze Behavior
• SHIFT + Clock Button - Gate Behaviors

Audio Inputs

Stereo Inputs
Expect a Modular Level signal, but will work with line level signals (However, certain things
may make these very loud on the outputs after saturation, etc.)
The left input is normalled to the right input when nothing is connected.

Audio Outputs

Stereo Outputs
Modular Level signals, roughly in a range between input level and 14Vpp when using a lot
of Corruption, etc.
11