Micro Mode; Bend - Playback Speed/Reverse; Break - T Raverse / Silence; T Raverse - Qu-Bit Electronix Data Bender Manual

At the lowest settings, it will only have a slight chance to add additional repeats, or move to
a new sub-section of the buffer
At the maximum settings, it can jump to any sub-section of the buffer, and has a high like-
lihood to do so. It can also set the repeats to anywhere above where the knob is set, and
add up to 90% silence to each repeat.

Micro Mode

T ake control of the microcosms of destruction and failure with discrete controls for the mod-
ule's parameters.

4. Bend - Playback Speed/Reverse

This control acts as playback speed going down 3 octaves and up 3 octaves
When the playback speed is forward the LED will be blue, unless it is on a specific multiple
(octave) above or below the original playback speed. Then it will be cyan.
When reversing, the LED will be green unless it is on a specific multiple above or below the
playback speed, then the LED will be gold.
Pressing Bend will toggle the playback to reverse.

5. Break - T raverse / Silence

Pressing the button or using a Gate will toggle between T raverse and Silence
When either the knob, CV or the Repeats setting changes the currently selected subsection,
the Break LED will blip gold.

T raverse

When the LED is not illuminated the break controls subsection traversal, allowing you to
select from each chunk of the active buffer.
On the far left of the knob, the first subsection will be selected.
On the far right of the knob, the last subsection (determined by Repeats) will be selected.
When Repeats is set to 1 (all the way left), this will have no effect.
13